usb: musb: omap2430: replace *_* with *-* in property names

No functional change. Replace *_* with *-* in property names of otg to
follow the general convention.

Signed-off-by: Kishon Vijay Abraham I <kishon@ti.com>
Signed-off-by: Felipe Balbi <balbi@ti.com>

1 files changed, 6 insertions, 6 deletions

diff --git a/Documentation/devicetree/bindings/usb/omap-usb.txt b/Documentation/devicetree/bindings/usb/omap-usb.txt
index 1b9f55fd96c0..662f0f1d2315 100644
--- a/Documentation/devicetree/bindings/usb/omap-usb.txt
+++ b/Documentation/devicetree/bindings/usb/omap-usb.txt
@@ -8,10 +8,10 @@ OMAP MUSB GLUE
    and disconnect.
  - multipoint : Should be "1" indicating the musb controller supports
    multipoint. This is a MUSB configuration-specific setting.
- - num_eps : Specifies the number of endpoints. This is also a
+ - num-eps : Specifies the number of endpoints. This is also a
    MUSB configuration-specific setting. Should be set to "16"
- - ram_bits : Specifies the ram address size. Should be set to "12"
- - interface_type : This is a board specific setting to describe the type of
+ - ram-bits : Specifies the ram address size. Should be set to "12"
+ - interface-type : This is a board specific setting to describe the type of
    interface between the controller and the phy. It should be "0" or "1"
    specifying ULPI and UTMI respectively.
  - mode : Should be "3" to represent OTG. "1" signifies HOST and "2"
@@ -29,14 +29,14 @@ usb_otg_hs: usb_otg_hs@4a0ab000 {
         ti,hwmods = "usb_otg_hs";
         ti,has-mailbox;
         multipoint = <1>;
-        num_eps = <16>;
-        ram_bits = <12>;
+        num-eps = <16>;
+        ram-bits = <12>;
         ctrl-module = <&omap_control_usb>;
 };
 
 Board specific device node entry
 &usb_otg_hs {
-        interface_type = <1>;
+        interface-type = <1>;
         mode = <3>;
         power = <50>;
 };