gpio: stmpe: fix up interrupt enable logic

The STMPE driver assumes that the passed in IRQ type is
for rising or falling IRQs, not both, even though the
hardware actually supports this perfectly well. Likewise
the check for level IRQs is done against just high or low
level types, not for the case where it is combined with
other IRQs.

Signed-off-by: Linus Walleij <linus.walleij@linaro.org>

1 files changed, 3 insertions, 3 deletions

diff --git a/drivers/gpio/gpio-stmpe.c b/drivers/gpio/gpio-stmpe.c
index b0b342787c37..866baa879473 100644
--- a/drivers/gpio/gpio-stmpe.c
+++ b/drivers/gpio/gpio-stmpe.c
@@ -127,19 +127,19 @@ static int stmpe_gpio_irq_set_type(struct irq_data *d, unsigned int type)
         int regoffset = offset / 8;
         int mask = 1 << (offset % 8);
 
-        if (type == IRQ_TYPE_LEVEL_LOW || type == IRQ_TYPE_LEVEL_HIGH)
+        if (type & IRQ_TYPE_LEVEL_LOW || type & IRQ_TYPE_LEVEL_HIGH)
                 return -EINVAL;
 
         /* STMPE801 doesn't have RE and FE registers */
         if (stmpe_gpio->stmpe->partnum == STMPE801)
                 return 0;
 
-        if (type == IRQ_TYPE_EDGE_RISING)
+        if (type & IRQ_TYPE_EDGE_RISING)
                 stmpe_gpio->regs[REG_RE][regoffset] |= mask;
         else
                 stmpe_gpio->regs[REG_RE][regoffset] &= ~mask;
 
-        if (type == IRQ_TYPE_EDGE_FALLING)
+        if (type & IRQ_TYPE_EDGE_FALLING)
                 stmpe_gpio->regs[REG_FE][regoffset] |= mask;
         else
                 stmpe_gpio->regs[REG_FE][regoffset] &= ~mask;