[TG3]: ethtool always report port is TP.

Even with fiber cards ethtool reports that the connected port is TP,
the patch fix this.

Signed-off-by: Karsten Keil <kkeil@suse.de>
Acked-by: Michael Chan <mchan@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

1 files changed, 5 insertions, 3 deletions

diff --git a/drivers/net/tg3.c b/drivers/net/tg3.c
index 2bd9592b75cd..e1b33a25a25f 100644
--- a/drivers/net/tg3.c
+++ b/drivers/net/tg3.c
@@ -7653,21 +7653,23 @@ static int tg3_get_settings(struct net_device *dev, struct ethtool_cmd *cmd)
                 cmd->supported |= (SUPPORTED_1000baseT_Half |
                                    SUPPORTED_1000baseT_Full);
 
-        if (!(tp->tg3_flags2 & TG3_FLG2_ANY_SERDES))
+        if (!(tp->tg3_flags2 & TG3_FLG2_ANY_SERDES)) {
                 cmd->supported |= (SUPPORTED_100baseT_Half |
                                   SUPPORTED_100baseT_Full |
                                   SUPPORTED_10baseT_Half |
                                   SUPPORTED_10baseT_Full |
                                   SUPPORTED_MII);
-        else
+                cmd->port = PORT_TP;
+        } else {
                 cmd->supported |= SUPPORTED_FIBRE;
+                cmd->port = PORT_FIBRE;
+        }
   
         cmd->advertising = tp->link_config.advertising;
         if (netif_running(dev)) {
                 cmd->speed = tp->link_config.active_speed;
                 cmd->duplex = tp->link_config.active_duplex;
         }
-        cmd->port = 0;
         cmd->phy_address = PHY_ADDR;
         cmd->transceiver = 0;
         cmd->autoneg = tp->link_config.autoneg;