tlan: Isolate external PHY when using internal PHY

When using internal 10 Mbps PHY, isolate the external PHY from MII bus.
External PHY must be kept powered up because it passes TX from tlan chip to
network.

This fixes weird link-loss problems under load with OC-2326 card at 10 Mbps.

Signed-off-by: Ondrej Zary <linux@rainbow-software.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

1 files changed, 4 insertions, 3 deletions

diff --git a/drivers/net/ethernet/ti/tlan.c b/drivers/net/ethernet/ti/tlan.c
index 1f21764fea53..6078342fe3f2 100644
--- a/drivers/net/ethernet/ti/tlan.c
+++ b/drivers/net/ethernet/ti/tlan.c
@@ -2528,9 +2528,10 @@ static void tlan_phy_power_down(struct net_device *dev)
         value = MII_GC_PDOWN | MII_GC_LOOPBK | MII_GC_ISOLATE;
         tlan_mii_sync(dev->base_addr);
         tlan_mii_write_reg(dev, priv->phy[priv->phy_num], MII_GEN_CTL, value);
-        if ((priv->phy_num == 0) &&
-            (priv->phy[1] != TLAN_PHY_NONE) &&
-            (!(priv->adapter->flags & TLAN_ADAPTER_USE_INTERN_10))) {
+        if ((priv->phy_num == 0) && (priv->phy[1] != TLAN_PHY_NONE)) {
+                /* if using internal PHY, the external PHY must be powered on */
+                if (priv->adapter->flags & TLAN_ADAPTER_USE_INTERN_10)
+                        value = MII_GC_ISOLATE; /* just isolate it from MII */
                 tlan_mii_sync(dev->base_addr);
                 tlan_mii_write_reg(dev, priv->phy[1], MII_GEN_CTL, value);
         }