[SCSI] qla2xxx: Use correct value for max vport in LOOP topology.

Use minimum value for max vport during firmware initialization in LOOP
topology. Using max vport value from get resource count in LOOP topology
causes firmware initialization failure.

Signed-off-by: Lalit Chandivade <lalit.chandivade@qlogic.com>
Signed-off-by: Andrew Vasquez <andrew.vasquez@qlogic.com>
Signed-off-by: James Bottomley <James.Bottomley@HansenPartnership.com>

1 files changed, 5 insertions, 1 deletions

diff --git a/drivers/scsi/qla2xxx/qla_init.c b/drivers/scsi/qla2xxx/qla_init.c
index 986501759ad4..14325c027336 100644
--- a/drivers/scsi/qla2xxx/qla_init.c
+++ b/drivers/scsi/qla2xxx/qla_init.c
@@ -1308,8 +1308,12 @@ qla2x00_init_rings(scsi_qla_host_t *vha)
 
         DEBUG(printk("scsi(%ld): Issue init firmware.\n", vha->host_no));
 
-        if (ha->flags.npiv_supported)
+        if (ha->flags.npiv_supported) {
+                if (ha->operating_mode == LOOP)
+                        ha->max_npiv_vports = MIN_MULTI_ID_FABRIC - 1;
                 mid_init_cb->count = cpu_to_le16(ha->max_npiv_vports);
+        }
+
 
         mid_init_cb->options = __constant_cpu_to_le16(BIT_1);