microblaze: Change temp register for cmdline

For copy was used r7 register when CONFIG_CMDLINE_BOOL option
is enabled. But r7 stores pointer to fdt that's why machine_early_init
not detect compiled-in DTB.

I also moved kernel PID setup to have TLB init in one block

Signed-off-by: Michal Simek <monstr@monstr.eu>

1 files changed, 7 insertions, 6 deletions

diff --git a/arch/microblaze/kernel/head.S b/arch/microblaze/kernel/head.S
index 30916193fcc7..cb7815cfe5ab 100644
--- a/arch/microblaze/kernel/head.S
+++ b/arch/microblaze/kernel/head.S
@@ -99,8 +99,8 @@ no_fdt_arg:
         tophys(r4,r4)                   /* convert to phys address */
         ori     r3, r0, COMMAND_LINE_SIZE - 1 /* number of loops */
 _copy_command_line:
-        lbu     r7, r5, r6 /* r7=r5+r6 - r5 contain pointer to command line */
-        sb      r7, r4, r6              /* addr[r4+r6]= r7*/
+        lbu     r2, r5, r6 /* r7=r5+r6 - r5 contain pointer to command line */
+        sb      r2, r4, r6              /* addr[r4+r6]= r7*/
         addik   r6, r6, 1               /* increment counting */
         bgtid   r3, _copy_command_line  /* loop for all entries       */
         addik   r3, r3, -1              /* descrement loop */
@@ -136,6 +136,11 @@ _invalidate:
         addik   r3, r3, -1
         /* sync */
 
+        /* Setup the kernel PID */
+        mts     rpid,r0                 /* Load the kernel PID */
+        nop
+        bri     4
+
         /*
          * We should still be executing code at physical address area
          * RAM_BASEADDR at this point. However, kernel code is at
@@ -146,10 +151,6 @@ _invalidate:
         addik   r3,r0, CONFIG_KERNEL_START /* Load the kernel virtual address */
         tophys(r4,r3)                   /* Load the kernel physical address */
 
-        mts     rpid,r0                 /* Load the kernel PID */
-        nop
-        bri     4
-
         /*
          * Configure and load two entries into TLB slots 0 and 1.
          * In case we are pinning TLBs, these are reserved in by the