#ifndef _X86_SPINLOCK_H_
#define _X86_SPINLOCK_H_
#include <asm/atomic.h>
#include <asm/rwlock.h>
#include <asm/page.h>
#include <asm/processor.h>
#include <linux/compiler.h>
/*
* Your basic SMP spinlocks, allowing only a single CPU anywhere
*
* Simple spin lock operations. There are two variants, one clears IRQ's
* on the local processor, one does not.
*
* These are fair FIFO ticket locks, which are currently limited to 256
* CPUs.
*
* (the type definitions are in asm/spinlock_types.h)
*/
#ifdef CONFIG_X86_32
typedef char _slock_t;
# define LOCK_INS_DEC "decb"
# define LOCK_INS_XCH "xchgb"
# define LOCK_INS_MOV "movb"
# define LOCK_INS_CMP "cmpb"
# define LOCK_PTR_REG "a"
#else
typedef int _slock_t;
# define LOCK_INS_DEC "decl"
# define LOCK_INS_XCH "xchgl"
# define LOCK_INS_MOV "movl"
# define LOCK_INS_CMP "cmpl"
# define LOCK_PTR_REG "D"
#endif
#if defined(CONFIG_X86_32) && \
(defined(CONFIG_X86_OOSTORE) || defined(CONFIG_X86_PPRO_FENCE))
/*
* On PPro SMP or if we are using OOSTORE, we use a locked operation to unlock
* (PPro errata 66, 92)
*/
# define UNLOCK_LOCK_PREFIX LOCK_PREFIX
#else
# define UNLOCK_LOCK_PREFIX
#endif
/*
* Ticket locks are conceptually two parts, one indicating the current head of
* the queue, and the other indicating the current tail. The lock is acquired
* by atomically noting the tail and incrementing it by one (thus adding
* ourself to the queue and noting our position), then waiting until the head
* becomes equal to the the initial value of the tail.
*
* We use an xadd covering *both* parts of the lock, to increment the tail and
* also load the position of the head, which takes care of memory ordering
* issues and should be optimal for the uncontended case. Note the tail must be
* in the high part, because a wide xadd increment of the low part would carry
* up and contaminate the high part.
*
* With fewer than 2^8 possible CPUs, we can use x86's partial registers to
* save some instructions and make the code more elegant. There really isn't
* much between them in performance though, especially as locks are out of line.
*/
#if (NR_CPUS < 256)
static inline int __raw_spin_is_locked(raw_spinlock_t *lock)
{
int tmp = *(volatile signed int *)(&(lock)->slock);
return (((tmp >> 8) & 0xff) != (tmp & 0xff));
}
static inline int __raw_spin_is_contended(raw_spinlock_t *lock)
{
int tmp = *(volatile signed int *)(&(lock)->slock);
return (((tmp >> 8) & 0xff) - (tmp & 0xff)) > 1;
}
static inline void __raw_spin_lock(raw_spinlock_t *lock)
{
short inc = 0x0100;
__asm__ __volatile__ (
LOCK_PREFIX "xaddw %w0, %1\n"
"1:\t"
"cmpb %h0, %b0\n\t"
"je 2f\n\t"
"rep ; nop\n\t"
"movb %1, %b0\n\t"
/* don't need lfence here, because loads are in-order */
"jmp 1b\n"
"2:"
:"+Q" (inc), "+m" (lock->slock)
:
:"memory", "cc");
}
#define __raw_spin_lock_flags(lock, flags) __raw_spin_lock(lock)
static inline int __raw_spin_trylock(raw_spinlock_t *lock)
{
int tmp;
short new;
asm volatile(
"movw %2,%w0\n\t"
"cmpb %h0,%b0\n\t"
"jne 1f\n\t"
"movw %w0,%w1\n\t"
"incb %h1\n\t"
"lock ; cmpxchgw %w1,%2\n\t"
"1:"
"sete %b1\n\t"
"movzbl %b1,%0\n\t"
:"=&a" (tmp), "=Q" (new), "+m" (lock->slock)
:
: "memory", "cc");
return tmp;
}
static inline void __raw_spin_unlock(raw_spinlock_t *lock)
{
__asm__ __volatile__(
UNLOCK_LOCK_PREFIX "incb %0"
:"+m" (lock->slock)
:
:"memory", "cc");
}
#else
static inline int __raw_spin_is_locked(raw_spinlock_t *lock)
{
int tmp = *(volatile signed int *)(&(lock)->slock);
return (((tmp >> 16) & 0xffff) != (tmp & 0xffff));
}
static inline int __raw_spin_is_contended(raw_spinlock_t *lock)
{
int tmp = *(volatile signed int *)(&(lock)->slock);
return (((tmp >> 16) & 0xffff) - (tmp & 0xffff)) > 1;
}
static inline void __raw_spin_lock(raw_spinlock_t *lock)
{
int inc = 0x00010000;
int tmp;
__asm__ __volatile__ (
"lock ; xaddl %0, %1\n"
"movzwl %w0, %2\n\t"
"shrl $16, %0\n\t"
"1:\t"
"cmpl %0, %2\n\t"
"je 2f\n\t"
"rep ; nop\n\t"
"movzwl %1, %2\n\t"
/* don't need lfence here, because loads are in-order */
"jmp 1b\n"
"2:"
:"+Q" (inc), "+m" (lock->slock), "=r" (tmp)
:
:"memory", "cc");
}
#define __raw_spin_lock_flags(lock, flags) __raw_spin_lock(lock)
static inline int __raw_spin_trylock(raw_spinlock_t *lock)
{
int tmp;
int new;
asm volatile(
"movl %2,%0\n\t"
"movl %0,%1\n\t"
"roll $16, %0\n\t"
"cmpl %0,%1\n\t"
"jne 1f\n\t"
"addl $0x00010000, %1\n\t"
"lock ; cmpxchgl %1,%2\n\t"
"1:"
"sete %b1\n\t"
"movzbl %b1,%0\n\t"
:"=&a" (tmp), "=r" (new), "+m" (lock->slock)
:
: "memory", "cc");
return tmp;
}
static inline void __raw_spin_unlock(raw_spinlock_t *lock)
{
__asm__ __volatile__(
UNLOCK_LOCK_PREFIX "incw %0"
:"+m" (lock->slock)
:
:"memory", "cc");
}
#endif
static inline void __raw_spin_unlock_wait(raw_spinlock_t *lock)
{
while (__raw_spin_is_locked(lock))
cpu_relax();
}
/*
* Read-write spinlocks, allowing multiple readers
* but only one writer.
*
* NOTE! it is quite common to have readers in interrupts
* but no interrupt writers. For those circumstances we
* can "mix" irq-safe locks - any writer needs to get a
* irq-safe write-lock, but readers can get non-irqsafe
* read-locks.
*
* On x86, we implement read-write locks as a 32-bit counter
* with the high bit (sign) being the "contended" bit.
*/
/**
* read_can_lock - would read_trylock() succeed?
* @lock: the rwlock in question.
*/
static inline int __raw_read_can_lock(raw_rwlock_t *lock)
{
return (int)(lock)->lock > 0;
}
/**
* write_can_lock - would write_trylock() succeed?
* @lock: the rwlock in question.
*/
static inline int __raw_write_can_lock(raw_rwlock_t *lock)
{
return (lock)->lock == RW_LOCK_BIAS;
}
static inline void __raw_read_lock(raw_rwlock_t *rw)
{
asm volatile(LOCK_PREFIX " subl $1,(%0)\n\t"
"jns 1f\n"
"call __read_lock_failed\n\t"
"1:\n"
::LOCK_PTR_REG (rw) : "memory");
}
static inline void __raw_write_lock(raw_rwlock_t *rw)
{
asm volatile(LOCK_PREFIX " subl %1,(%0)\n\t"
"jz 1f\n"
"call __write_lock_failed\n\t"
"1:\n"
::LOCK_PTR_REG (rw), "i" (RW_LOCK_BIAS) : "memory");
}
static inline int __raw_read_trylock(raw_rwlock_t *lock)
{
atomic_t *count = (atomic_t *)lock;
atomic_dec(count);
if (atomic_read(count) >= 0)
return 1;
atomic_inc(count);
return 0;
}
static inline int __raw_write_trylock(raw_rwlock_t *lock)
{
atomic_t *count = (atomic_t *)lock;
if (atomic_sub_and_test(RW_LOCK_BIAS, count))
return 1;
atomic_add(RW_LOCK_BIAS, count);
return 0;
}
static inline void __raw_read_unlock(raw_rwlock_t *rw)
{
asm volatile(LOCK_PREFIX "incl %0" :"+m" (rw->lock) : : "memory");
}
static inline void __raw_write_unlock(raw_rwlock_t *rw)
{
asm volatile(LOCK_PREFIX "addl %1, %0"
: "+m" (rw->lock) : "i" (RW_LOCK_BIAS) : "memory");
}
#define _raw_spin_relax(lock) cpu_relax()
#define _raw_read_relax(lock) cpu_relax()
#define _raw_write_relax(lock) cpu_relax()
#endif
