/*
* Copyright (c) 2008-2009 Atheros Communications Inc.
*
* Permission to use, copy, modify, and/or distribute this software for any
* purpose with or without fee is hereby granted, provided that the above
* copyright notice and this permission notice appear in all copies.
*
* THE SOFTWARE IS PROVIDED "AS IS" AND THE AUTHOR DISCLAIMS ALL WARRANTIES
* WITH REGARD TO THIS SOFTWARE INCLUDING ALL IMPLIED WARRANTIES OF
* MERCHANTABILITY AND FITNESS. IN NO EVENT SHALL THE AUTHOR BE LIABLE FOR
* ANY SPECIAL, DIRECT, INDIRECT, OR CONSEQUENTIAL DAMAGES OR ANY DAMAGES
* WHATSOEVER RESULTING FROM LOSS OF USE, DATA OR PROFITS, WHETHER IN AN
* ACTION OF CONTRACT, NEGLIGENCE OR OTHER TORTIOUS ACTION, ARISING OUT OF
* OR IN CONNECTION WITH THE USE OR PERFORMANCE OF THIS SOFTWARE.
*/
#include <linux/nl80211.h>
#include <linux/pci.h>
#include "ath9k.h"
static DEFINE_PCI_DEVICE_TABLE(ath_pci_id_table) = {
{ PCI_VDEVICE(ATHEROS, 0x0023) }, /* PCI */
{ PCI_VDEVICE(ATHEROS, 0x0024) }, /* PCI-E */
{ PCI_VDEVICE(ATHEROS, 0x0027) }, /* PCI */
{ PCI_VDEVICE(ATHEROS, 0x0029) }, /* PCI */
{ PCI_VDEVICE(ATHEROS, 0x002A) }, /* PCI-E */
{ PCI_VDEVICE(ATHEROS, 0x002B) }, /* PCI-E */
{ PCI_VDEVICE(ATHEROS, 0x002C) }, /* PCI-E 802.11n bonded out */
{ PCI_VDEVICE(ATHEROS, 0x002D) }, /* PCI */
{ PCI_VDEVICE(ATHEROS, 0x002E) }, /* PCI-E */
{ PCI_VDEVICE(ATHEROS, 0x0030) }, /* PCI-E AR9300 */
{ 0 }
};
/* return bus cachesize in 4B word units */
static void ath_pci_read_cachesize(struct ath_common *common, int *csz)
{
struct ath_softc *sc = (struct ath_softc *) common->priv;
u8 u8tmp;
pci_read_config_byte(to_pci_dev(sc->dev), PCI_CACHE_LINE_SIZE, &u8tmp);
*csz = (int)u8tmp;
/*
* This check was put in to avoid "unplesant" consequences if
* the bootrom has not fully initialized all PCI devices.
* Sometimes the cache line size register is not set
*/
if (*csz == 0)
*csz = DEFAULT_CACHELINE >> 2; /* Use the default size */
}
static bool ath_pci_eeprom_read(struct ath_common *common, u32 off, u16 *data)
{
struct ath_hw *ah = (struct ath_hw *) common->ah;
common->ops->read(ah, AR5416_EEPROM_OFFSET + (off << AR5416_EEPROM_S));
if (!ath9k_hw_wait(ah,
AR_EEPROM_STATUS_DATA,
AR_EEPROM_STATUS_DATA_BUSY |
AR_EEPROM_STATUS_DATA_PROT_ACCESS, 0,
AH_WAIT_TIMEOUT)) {
return false;
}
*data = MS(common->ops->read(ah, AR_EEPROM_STATUS_DATA),
AR_EEPROM_STATUS_DATA_VAL);
return true;
}
/*
* Bluetooth coexistance requires disabling ASPM.
*/
static void ath_pci_bt_coex_prep(struct ath_common *common)
{
struct ath_softc *sc = (struct ath_softc *) common->priv;
struct pci_dev *pdev = to_pci_dev(sc->dev);
u8 aspm;
if (!pdev->is_pcie)
return;
pci_read_config_byte(pdev, ATH_PCIE_CAP_LINK_CTRL, &aspm);
aspm &= ~(ATH_PCIE_CAP_LINK_L0S | ATH_PCIE_CAP_LINK_L1);
pci_write_config_byte(pdev, ATH_PCIE_CAP_LINK_CTRL, aspm);
}
static const struct ath_bus_ops ath_pci_bus_ops = {
.ath_bus_type = ATH_PCI,
.read_cachesize = ath_pci_read_cachesize,
.eeprom_read = ath_pci_eeprom_read,
.bt_coex_prep = ath_pci_bt_coex_prep,
};
static int ath_pci_probe(struct pci_dev *pdev, const struct pci_device_id *id)
{
void __iomem *mem;
struct ath_wiphy *aphy;
struct ath_softc *sc;
struct ieee80211_hw *hw;
u8 csz;
u16 subsysid;
u32 val;
int ret = 0;
char hw_name[64];
if (pci_enable_device(pdev))
return -EIO;
ret = pci_set_dma_mask(pdev, DMA_BIT_MASK(32));
if (ret) {
printk(KERN_ERR "ath9k: 32-bit DMA not available\n");
goto err_dma;
}
ret = pci_set_consistent_dma_mask(pdev, DMA_BIT_MASK(32));
if (ret) {
printk(KERN_ERR "ath9k: 32-bit DMA consistent "
"DMA enable failed\n");
goto err_dma;
}
/*
* Cache line size is used to size and align various
* structures used to communicate with the hardware.
*/
pci_read_config_byte(pdev, PCI_CACHE_LINE_SIZE, &csz);
if (csz == 0) {
/*
* Linux 2.4.18 (at least) writes the cache line size
* register as a 16-bit wide register which is wrong.
* We must have this setup properly for rx buffer
* DMA to work so force a reasonable value here if it
* comes up zero.
*/
csz = L1_CACHE_BYTES / sizeof(u32);
pci_write_config_byte(pdev, PCI_CACHE_LINE_SIZE, csz);
}
/*
* The default setting of latency timer yields poor results,
* set it to the value used by other systems. It may be worth
* tweaking this setting more.
*/
pci_write_config_byte(pdev, PCI_LATENCY_TIMER, 0xa8);
pci_set_master(pdev);
/*
* Disable the RETRY_TIMEOUT register (0x41) to keep
* PCI Tx retries from interfering with C3 CPU state.
*/
pci_read_config_dword(pdev, 0x40, &val);
if ((val & 0x0000ff00) != 0)
pci_write_config_dword(pdev, 0x40, val & 0xffff00ff);
ret = pci_request_region(pdev, 0, "ath9k");
if (ret) {
dev_err(&pdev->dev, "PCI memory region reserve error\n");
ret = -ENODEV;
goto err_region;
}
mem = pci_iomap(pdev, 0, 0);
if (!mem) {
printk(KERN_ERR "PCI memory map error\n") ;
ret = -EIO;
goto err_iomap;
}
hw = ieee80211_alloc_hw(sizeof(struct ath_wiphy) +
sizeof(struct ath_softc), &ath9k_ops);
if (!hw) {
dev_err(&pdev->dev, "No memory for ieee80211_hw\n");
ret = -ENOMEM;
goto err_alloc_hw;
}
SET_IEEE80211_DEV(hw, &pdev->dev);
pci_set_drvdata(pdev, hw);
aphy = hw->priv;
sc = (struct ath_softc *) (aphy + 1);
aphy->sc = sc;
aphy->hw = hw;
sc->pri_wiphy = aphy;
sc->hw = hw;
sc->dev = &pdev->dev;
sc->mem = mem;
/* Will be cleared in ath9k_start() */
sc->sc_flags |= SC_OP_INVALID;
ret = request_irq(pdev->irq, ath_isr, IRQF_SHARED, "ath9k", sc);
if (ret) {
dev_err(&pdev->dev, "request_irq failed\n");
goto err_irq;
}
sc->irq = pdev->irq;
pci_read_config_word(pdev, PCI_SUBSYSTEM_ID, &subsysid);
ret = ath9k_init_device(id->device, sc, subsysid, &ath_pci_bus_ops);
if (ret) {
dev_err(&pdev->dev, "Failed to initialize device\n");
goto err_init;
}
ath9k_hw_name(sc->sc_ah, hw_name, sizeof(hw_name));
printk(KERN_INFO
"%s: %s mem=0x%lx, irq=%d\n",
wiphy_name(hw->wiphy),
hw_name,
(unsigned long)mem, pdev->irq);
return 0;
err_init:
free_irq(sc->irq, sc);
err_irq:
ieee80211_free_hw(hw);
err_alloc_hw:
pci_iounmap(pdev, mem);
err_iomap:
pci_release_region(pdev, 0);
err_region:
/* Nothing */
err_dma:
pci_disable_device(pdev);
return ret;
}
static void ath_pci_remove(struct pci_dev *pdev)
{
struct ieee80211_hw *hw = pci_get_drvdata(pdev);
struct ath_wiphy *aphy = hw->priv;
struct ath_softc *sc = aphy->sc;
void __iomem *mem = sc->mem;
ath9k_deinit_device(sc);
free_irq(sc->irq, sc);
ieee80211_free_hw(sc->hw);
pci_iounmap(pdev, mem);
pci_disable_device(pdev);
pci_release_region(pdev, 0);
}
#ifdef CONFIG_PM
static int ath_pci_suspend(struct pci_dev *pdev, pm_message_t state)
{
struct ieee80211_hw *hw = pci_get_drvdata(pdev);
struct ath_wiphy *aphy = hw->priv;
struct ath_softc *sc = aphy->sc;
ath9k_hw_set_gpio(sc->sc_ah, sc->sc_ah->led_pin, 1);
pci_save_state(pdev);
pci_disable_device(pdev);
pci_set_power_state(pdev, PCI_D3hot);
return 0;
}
static int ath_pci_resume(struct pci_dev *pdev)
{
struct ieee80211_hw *hw = pci_get_drvdata(pdev);
struct ath_wiphy *aphy = hw->priv;
struct ath_softc *sc = aphy->sc;
u32 val;
int err;
pci_restore_state(pdev);
err = pci_enable_device(pdev);
if (err)
return err;
/*
* Suspend/Resume resets the PCI configuration space, so we have to
* re-disable the RETRY_TIMEOUT register (0x41) to keep
* PCI Tx retries from interfering with C3 CPU state
*/
pci_read_config_dword(pdev, 0x40, &val);
if ((val & 0x0000ff00) != 0)
pci_write_config_dword(pdev, 0x40, val & 0xffff00ff);
/* Enable LED */
ath9k_hw_cfg_output(sc->sc_ah, sc->sc_ah->led_pin,
AR_GPIO_OUTPUT_MUX_AS_OUTPUT);
ath9k_hw_set_gpio(sc->sc_ah, sc->sc_ah->led_pin, 1);
return 0;
}
#endif /* CONFIG_PM */
MODULE_DEVICE_TABLE(pci, ath_pci_id_table);
static struct pci_driver ath_pci_driver = {
.name = "ath9k",
.id_table = ath_pci_id_table,
.probe = ath_pci_probe,
.remove = ath_pci_remove,
#ifdef CONFIG_PM
.suspend = ath_pci_suspend,
.resume = ath_pci_resume,
#endif /* CONFIG_PM */
};
int ath_pci_init(void)
{
return pci_register_driver(&ath_pci_driver);
}
void ath_pci_exit(void)
{
pci_unregister_driver(&ath_pci_driver);
}
