* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/cjb/mmc:
  mmc: sdhci: 8-bit bus width changes
  mmc: sdio: fix runtime PM anomalies by introducing MMC_CAP_POWER_OFF_CARD
  mmc: sdio: fix nasty oops in mmc_sdio_detect
  mmc: omap4: hsmmc: Fix improper card detection while booting
  mmc: fix rmmod race for hosts using card-detection polling
  mmc: sdhci: Fix crash on boot with C0 stepping Moorestown platforms
  mmc: sdhci-esdhc-imx: enable QUIRK_NO_MULTIBLOCK only for i.MX25 and i.MX35
  mmc: sdhci-esdhc-imx: fix timeout on i.MX's sdhci
  mmc: sdhci: Properly enable SDIO IRQ wakeups
  mmc: ushc: Return proper error code for ushc_probe()
  mmc: Fix printing of card DDR type

Some board/card/host configurations are not capable of powering off the
card after boot.

To support such configurations, and to allow smoother transition to
runtime PM behavior, MMC_CAP_POWER_OFF_CARD is added, so hosts need to
explicitly indicate whether it's OK to power off their cards after boot.

SDIO core will enable runtime PM for a card only if that cap is set.
As a result, the card will be powered down after boot, and will only
be powered up again when a driver is loaded (and then it's up to the
driver to decide whether power will be kept or not).

This will prevent sdio_bus_probe() failures with setups that do not
support powering off the card.

Reported-and-tested-by: Daniel Drake <dsd@laptop.org>
Reported-and-tested-by: Arnd Hannemann <arnd@arndnet.de>
Signed-off-by: Ohad Ben-Cohen <ohad@wizery.com>
Signed-off-by: Chris Ball <cjb@laptop.org>

Presently the extern inline case results in a compiler warning on ARM due
to the memory barrier definition used in the I/O routines. These
ultimately all want to be static inline anyways, so just convert them all
in place.

Signed-off-by: Paul Mundt <lethal@linux-sh.org>

In some platforms (e.g. AP4EVB) the card detect pin of a slot is not
directly connected to the sh_mmcif controller, so that polling needs
to be used. To overcome the overhead induced by querying the controller
on each poll cycle, card detection can be handled in the platform code
more efficiently.
This patch exposes a get_cd hook for that purpose.

Signed-off-by: Arnd Hannemann <arnd@arndnet.de>
Tested-by: Yusuke Goda <yusuke.goda.sx@renesas.com>
Signed-off-by: Samuel Ortiz <sameo@linux.intel.com>

* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/cjb/mmc: (66 commits)
  mmc: add new sdhci-pxa driver for Marvell SoCs
  mmc: make number of mmcblk minors configurable
  mmc_spi: Recover from CRC errors for r/w operation over SPI.
  mmc: sdhci-pltfm: add -pltfm driver for imx35/51
  mmc: sdhci-of-esdhc: factor out common stuff
  mmc: sdhci_pltfm: pass more data on custom init call
  mmc: sdhci: introduce get_ro private write-protect hook
  mmc: sdhci-pltfm: move .h file into appropriate subdir
  mmc: sdhci-pltfm: Add structure for host-specific data
  mmc: fix cb710 kconfig dependency warning
  mmc: cb710: remove debugging printk (info duplicated from mmc-core)
  mmc: cb710: clear irq handler on init() error path
  mmc: cb710: remove unnecessary msleep()
  mmc: cb710: implement get_cd() callback
  mmc: cb710: partially demystify clock selection
  mmc: add a file to debugfs for changing host clock at runtime
  mmc: sdhci: allow for eMMC 74 clock generation by controller
  mmc: sdhci: highspeed: check for mmc as well as sd cards
  mmc: sdhci: Add Moorestown device support
  mmc: sdhci: Intel Medfield support
  ...

The custom init call may need more data to perform its job, so we pass
it a pointer to pdata, too. Also, always use the platform_id specific
data even if platform_data is present. Doing that, platform_data can
additionally be parsed by init() for board-specific information (via
sdhci->mmc->parent).

(Note: the old behaviour was that you could override the platform_id
specific data with your own. However, one can still do this by using the
"sdhci" id instead of "sdhci-<something>".)

Signed-off-by: Wolfram Sang <w.sang@pengutronix.de>
Tested-by: Eric Bénard <eric@eukrea.com>
Signed-off-by: Chris Ball <cjb@laptop.org>

Make use of the include/linux/mmc directory.

Signed-off-by: Wolfram Sang <w.sang@pengutronix.de>
Acked-by: Anton Vorontsov <cbouatmailru@gmail.com>
Tested-by: Eric Bénard <eric@eukrea.com>
Signed-off-by: Chris Ball <cjb@laptop.org>

Allow power save/restore and their relevant mmc_bus_ops handlers
exit with a return value.

Signed-off-by: Ohad Ben-Cohen <ohad@wizery.com>
Tested-by: Luciano Coelho <luciano.coelho@nokia.com>
Signed-off-by: Chris Ball <cjb@laptop.org>

Some platforms based on sdhci-pltfm need to set their own quirks.
Previously to this patch, the quirks were in drivers/mmc/host/sdhci.h.

This patch splits drivers/mmc/host/sdhci.h into two parts:

* drivers/mmc/host/sdhci.h  includes the HC registers and I/O accessors.
* include/linux/mmc/sdhci.h includes the sdhci structure and quirks.

Instead of including drivers/mmc/host/sdhci.h, -pltfm drivers should
now include include/linux/mmc/sdhci.h and include/linux/sdhci-pltfm.h.

This patch avoids adding/changing the calls/flags in the
sdhci_pltfm_data structure.  It has been tested on STM platforms
(e.g. STx7106, STx7108, STx5206) where the driver is configured
and used as shown in the example below:

[snip]
static int mmc_pad_resources(struct sdhci_host *sdhci)
{
	if (!devm_stm_pad_claim(sdhci->mmc->parent,
				&stx7108_mmc_pad_config,
				dev_name(sdhci->mmc->parent)))
		return -ENODEV;

	return 0;
}

static struct sdhci_pltfm_data stx7108_mmc_platform_data = {
	.init = mmc_pad_resources,
	.quirks = SDHCI_QUIRK_NO_ENDATTR_IN_NOPDESC,
};

static struct platform_device stx7108_mmc_device = {
	.name = "sdhci",
[snip]

Note: drivers/mmc/host/sdhci.h now also includes linux/mmc/sdhci.h,
and no modifications should be needed on other sdhci-<XXX> drivers.

Signed-off-by: Giuseppe Cavallaro <peppe.cavallaro@st.com>
Reviewed-by: Wolfram Sang <w.sang@pengutronix.de>
Signed-off-by: Chris Ball <cjb@laptop.org>

One flaw with DDR support is that MMC core does not inform the driver
which DDR mode it has selected.  This patch expands the ios->ddr flag
to do that.

Signed-off-by: Adrian Hunter <adrian.hunter@nokia.com>
Signed-off-by: Chris Ball <cjb@laptop.org>