litmus-rt.git/drivers/net/tulip, branch wip-default-clustering

de2104x: fix ethtool

2010-09-27T22:40:29+00:00

When the interface is up, using ethtool breaks it because:
a) link is put down but media_timer interval is not shortened to NO_LINK
b) rxtx is stopped but not restarted

Also manual 10baseT-HD (and probably FD too - untested) mode does not work -
the link is forced up, packets are transmitted but nothing is received.
Changing CSR14 value to match documentation (not disabling link check) fixes this.

Signed-off-by: Ondrej Zary 
Acked-by: Jeff Garzik 
Signed-off-by: David S. Miller

de2104x: fix TP link detection

2010-09-26T22:51:55+00:00

Compex FreedomLine 32 PnP-PCI2 cards have only TP and BNC connectors but the
SROM contains AUI port too. When TP loses link, the driver switches to
non-existing AUI port (which reports that carrier is always present).

Connecting TP back generates LinkPass interrupt but de_media_interrupt() is
broken - it only updates the link state of currently connected media, ignoring
the fact that LinkPass and LinkFail bits of MacStatus register belong to the
TP port only (the chip documentation says that).

This patch changes de_media_interrupt() to switch media to TP when link goes
up (and media type is not locked) and also to update the link state only when
the TP port is used.

Also the NonselPortActive (and also SelPortActive) bits of SIAStatus register
need to be cleared (by writing 1) after reading or they're useless.

Signed-off-by: Ondrej Zary 
Acked-by: Jeff Garzik 
Signed-off-by: David S. Miller

de2104x: fix power management

2010-09-26T22:49:38+00:00

At least my 21041 cards come out of suspend with bus mastering disabled so
they did not work after resume(no data transferred).
After adding pci_set_master(), the driver oopsed immediately on resume -
because de_clean_rings() is called on suspend but de_init_rings() call
was missing in resume.

Also disable link (reset SIA) before sleep (de4x5 does this too).

Signed-off-by: Ondrej Zary 
Acked-by: Jeff Garzik 
Signed-off-by: David S. Miller

de2104x: disable autonegotiation on broken hardware

2010-09-25T05:40:46+00:00

At least on older 21041-AA chips (mine is rev. 11), TP duplex autonegotiation
causes the card not to work at all (link is up but no packets are transmitted).

de4x5 disables autonegotiation completely. But it seems to work on newer
(21041-PA rev. 21) so disable it only on rev<20 chips.

Signed-off-by: Ondrej Zary 
Acked-by: Jeff Garzik 
Signed-off-by: David S. Miller

Merge branch 'for-next' of git://git.kernel.org/pub/scm/linux/kernel/git/jikos/trivial

2010-08-04T22:31:02+00:00

* 'for-next' of git://git.kernel.org/pub/scm/linux/kernel/git/jikos/trivial: (48 commits)
  Documentation: update broken web addresses.
  fix comment typo "choosed" -> "chosen"
  hostap:hostap_hw.c Fix typo in comment
  Fix spelling contorller -> controller in comments
  Kconfig.debug: FAIL_IO_TIMEOUT: typo Faul -> Fault
  fs/Kconfig: Fix typo Userpace -> Userspace
  Removing dead MACH_U300_BS26
  drivers/infiniband: Remove unnecessary casts of private_data
  fs/ocfs2: Remove unnecessary casts of private_data
  libfc: use ARRAY_SIZE
  scsi: bfa: use ARRAY_SIZE
  drm: i915: use ARRAY_SIZE
  drm: drm_edid: use ARRAY_SIZE
  synclink: use ARRAY_SIZE
  block: cciss: use ARRAY_SIZE
  comment typo fixes: charater => character
  fix comment typos concerning "challenge"
  arm: plat-spear: fix typo in kerneldoc
  reiserfs: typo comment fix
  update email address
  ...

Merge git://git.kernel.org/pub/scm/linux/kernel/git/davem/net-next-2.6

2010-08-04T18:47:58+00:00

* git://git.kernel.org/pub/scm/linux/kernel/git/davem/net-next-2.6: (1443 commits)
  phy/marvell: add 88ec048 support
  igb: Program MDICNFG register prior to PHY init
  e1000e: correct MAC-PHY interconnect register offset for 82579
  hso: Add new product ID
  can: Add driver for esd CAN-USB/2 device
  l2tp: fix export of header file for userspace
  can-raw: Fix skb_orphan_try handling
  Revert "net: remove zap_completion_queue"
  net: cleanup inclusion
  phy/marvell: add 88e1121 interface mode support
  u32: negative offset fix
  net: Fix a typo from "dev" to "ndev"
  igb: Use irq_synchronize per vector when using MSI-X
  ixgbevf: fix null pointer dereference due to filter being set for VLAN 0
  e1000e: Fix irq_synchronize in MSI-X case
  e1000e: register pm_qos request on hardware activation
  ip_fragment: fix subtracting PPPOE_SES_HLEN from mtu twice
  net: Add getsockopt support for TCP thin-streams
  cxgb4: update driver version
  cxgb4: add new PCI IDs
  ...

Manually fix up conflicts in:
 - drivers/net/e1000e/netdev.c: due to pm_qos registration
   infrastructure changes
 - drivers/net/phy/marvell.c: conflict between adding 88ec048 support
   and cleaning up the IDs
 - drivers/net/wireless/ipw2x00/ipw2100.c: trivial ipw2100_pm_qos_req
   conflict (registration change vs marking it static)

Merge branch 'master' into for-next

2010-08-04T13:14:38+00:00

Tulip: don't initialize SBE xT3E3 WAN ports.

2010-08-02T23:03:29+00:00

SBE 2T3E3 cards use DECchips 21143 but they need a different driver.
Don't even try to use a normal tulip driver with them.

Signed-off-by: Krzysztof Hałasa 
Signed-off-by: David S. Miller

tulip: formatting of pointers in printk()

2010-07-14T22:06:10+00:00

Use %p instead of %08x in printk().

Signed-off-by: Kulikov Vasiliy 
Signed-off-by: David S. Miller

fix typos concerning "initiali[zs]e"

2010-06-16T16:05:05+00:00

Signed-off-by: Uwe Kleine-König 
Signed-off-by: Jiri Kosina