The block layer does not support very low sector count restrictions
so we need to be prepared to handle bigger requests than we can send
directly to the controller.

Problem found by Manuel Lauss.

Signed-off-by: Pierre Ossman <pierre@ossman.eu>

* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/drzeus/mmc: (42 commits)
  atmel-mci: fix sdc_reg typo
  tmio_mmc: add maintainer
  mmc: Add OpenFirmware bindings for SDHCI driver
  sdhci: Add quirk for forcing maximum block size to 2048 bytes
  sdhci: Add quirk for controllers that need IRQ re-init after reset
  sdhci: Add quirk for controllers that need small delays for PIO
  sdhci: Add set_clock callback and a quirk for nonstandard clocks
  sdhci: Add get_{max,timeout}_clock callbacks
  sdhci: Add support for hosts reporting inverted write-protect state
  sdhci: Add support for card-detection polling
  sdhci: Enable only relevant (DMA/PIO) interrupts during transfers
  sdhci: Split card-detection IRQs management from sdhci_init()
  sdhci: Add support for bus-specific IO memory accessors
  mmc_spi: adjust for delayed data token response
  omap_hsmmc: Wait for SDBP
  omap_hsmmc: Fix MMC3 dma
  omap_hsmmc: Disable SDBP at suspend
  omap_hsmmc: Do not prefix slot name
  omap_hsmmc: Allow cover switch to cause rescan
  omap_hsmmc: Add 8-bit bus width mode support
  ...

Signed-off-by: Alexey Dobriyan <adobriyan@gmail.com>
Cc: Alan Cox <alan@lxorguk.ukuu.org.uk>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>

Currently we are using an explicit udev rule to trigger loading of the
mmc-block module when an MMC or SD card is detected:

    SUBSYSTEM=="mmc", RUN+="/sbin/modprobe -Qba mmc-block"

It makes much more sense for the mmc bus driver and the mmc-block module to
share MODALIAS information so that they are linked automatically.

There is no real information of use in the MMC system at the current time.
All devices inserted require us to load the mmc-block device.  Until such
time as useful parameters exist simply reflect the module linkage via
the module alias below:

	mmc:block

Signed-off-by: Andy Whitcroft <apw@canonical.com>
Signed-off-by: Pierre Ossman <drzeus@drzeus.cx>

Due to a typo in the Basic Read test, it's currently identical to the
Basic Write test.  Fix this.

Signed-off-by: Rabin Vincent <rabin@rab.in>
Signed-off-by: Pierre Ossman <drzeus@drzeus.cx>

Signed-off-by: Yi Li <yi.li@analog.com>
Signed-off-by: Bryan Wu <cooloney@kernel.org>
Signed-off-by: Pierre Ossman <drzeus@drzeus.cx>

If a card encounters an ECC error while reading a sector it will
timeout.  Instead of reporting the entire I/O request as having
an error, redo the I/O one sector at a time so that all readable
sectors are provided to the upper layers.

Signed-off-by: Adrian Hunter <ext-adrian.hunter@nokia.com>
Signed-off-by: Pierre Ossman <drzeus@drzeus.cx>

Add command response and card status to error
messages.

Signed-off-by: Adrian Hunter <ext-adrian.hunter@nokia.com>
Signed-off-by: Pierre Ossman <drzeus@drzeus.cx>

sg_init_one is reading a be32, annotate as such.

Signed-off-by: Harvey Harrison <harvey.harrison@gmail.com>
Signed-off-by: Pierre Ossman <drzeus@drzeus.cx>

Signed-off-by: Al Viro <viro@zeniv.linux.org.uk>