From 7669896f499e1bce5cfb38f2685ff583ecdb24dd Mon Sep 17 00:00:00 2001 From: Hans de Goede Date: Wed, 9 Dec 2009 20:36:01 +0100 Subject: hwmon: (f71882fg) Add support for the f71889fg (version 2) This adds support for the Fintek f71889fg to the f71882fg driver, many thanks to Gerd v. Egidy for providing (remote) access to a machine which such an ic. Note that this bit of the patch: - val = SENSORS_LIMIT(val, 0, 255); + + if (data->type == f71889fg) + val = SENSORS_LIMIT(val, -128, 127); + else + val = SENSORS_LIMIT(val, 0, 127); Changes behaviour for already supported models, the new behaviour is correct as the already supported models have bit 7 of the involved registers fixed at 0, so the previous behaviour which allowed setting temp zone limits > 127 was not correct. Signed-off-by: Hans de Goede Signed-off-by: Jean Delvare --- Documentation/hwmon/f71882fg | 10 ++++++++++ 1 file changed, 10 insertions(+) (limited to 'Documentation/hwmon/f71882fg') diff --git a/Documentation/hwmon/f71882fg b/Documentation/hwmon/f71882fg index bee4c30bc1e..a7952c2bd95 100644 --- a/Documentation/hwmon/f71882fg +++ b/Documentation/hwmon/f71882fg @@ -14,6 +14,10 @@ Supported chips: Prefix: 'f71882fg' Addresses scanned: none, address read from Super I/O config space Datasheet: Available from the Fintek website + * Fintek F71889FG + Prefix: 'f71889fg' + Addresses scanned: none, address read from Super I/O config space + Datasheet: Should become available on the Fintek website soon * Fintek F8000 Prefix: 'f8000' Addresses scanned: none, address read from Super I/O config space @@ -51,6 +55,12 @@ supported. The right one to use depends on external circuitry on the motherboard, so the driver assumes that the BIOS set the method properly. +Note that the lowest numbered temperature zone trip point corresponds to +to the border between the highest and one but highest temperature zones, and +vica versa. So the temperature zone trip points 1-4 (or 1-2) go from high temp +to low temp! This is how things are implemented in the IC, and the driver +mimicks this. + There are 2 modes to specify the speed of the fan, PWM duty cycle (or DC voltage) mode, where 0-100% duty cycle (0-100% of 12V) is specified. And RPM mode where the actual RPM of the fan (as measured) is controlled and the speed -- cgit v1.2.2