signal: Explicitly call force_sig_fault on current

Update the calls of force_sig_fault that pass in a variable that is
set to current earlier to explicitly use current.

This is to make the next change that removes the task parameter
from force_sig_fault easier to verify.

Signed-off-by: "Eric W. Biederman" <ebiederm@xmission.com>

1 files changed, 2 insertions, 2 deletions

diff --git a/arch/nds32/mm/fault.c b/arch/nds32/mm/fault.c
index 68d5f2a27f38..38441113c202 100644
--- a/arch/nds32/mm/fault.c
+++ b/arch/nds32/mm/fault.c
@@ -271,7 +271,7 @@ bad_area_nosemaphore:
                 tsk->thread.address = addr;
                 tsk->thread.error_code = error_code;
                 tsk->thread.trap_no = entry;
-                force_sig_fault(SIGSEGV, si_code, (void __user *)addr, tsk);
+                force_sig_fault(SIGSEGV, si_code, (void __user *)addr, current);
                 return;
         }
 
@@ -340,7 +340,7 @@ do_sigbus:
         tsk->thread.address = addr;
         tsk->thread.error_code = error_code;
         tsk->thread.trap_no = entry;
-        force_sig_fault(SIGBUS, BUS_ADRERR, (void __user *)addr, tsk);
+        force_sig_fault(SIGBUS, BUS_ADRERR, (void __user *)addr, current);
 
         return;