at86rf230: add warning if edge-triggered irq

While testing I experience a deadlock while using the at86rf233 on a
raspberry pi. The reason was an edge triggered gpio irq because the irq
triggered while irq was disabled. This issue doesn't happend on a level
triggered irq because the irq will hit after calling enable_irq.

This patch adds a warning that it's not recommended to use a edge-triggered
irq type. Also change the examples to high-level irqtype.

Signed-off-by: Alexander Aring <alex.aring@gmail.com>
Signed-off-by: Marcel Holtmann <marcel@holtmann.org>

1 files changed, 3 insertions, 2 deletions

diff --git a/Documentation/devicetree/bindings/net/ieee802154/at86rf230.txt b/Documentation/devicetree/bindings/net/ieee802154/at86rf230.txt
index 1ae5100fea14..168f1be50912 100644
--- a/Documentation/devicetree/bindings/net/ieee802154/at86rf230.txt
+++ b/Documentation/devicetree/bindings/net/ieee802154/at86rf230.txt
@@ -6,7 +6,8 @@ Required properties:
   - spi-max-frequency:  maximal bus speed, should be set to 7500000 depends
                         sync or async operation mode
   - reg:                the chipselect index
-  - interrupts:         the interrupt generated by the device
+  - interrupts:         the interrupt generated by the device. Non high-level
+                        can occur deadlocks while handling isr.
 
 Optional properties:
   - reset-gpio:         GPIO spec for the rstn pin
@@ -20,7 +21,7 @@ Example:
                 compatible = "atmel,at86rf231";
                 spi-max-frequency = <7500000>;
                 reg = <0>;
-                interrupts = <19 1>;
+                interrupts = <19 4>;
                 interrupt-parent = <&gpio3>;
                 xtal-trim = /bits/ 8 <0x06>;
         };